Liebherr HC1050B Guide de l'utilisateur télécharger pdf (Page 28)

Fully Integrated

24" Model: HC 1000B, HC 1001B

1. Start with the lower door of the freezer compartment:

The freezer door height is 24-24/32" (663 mm). In order to

cover the lower part of the appliance, increase the height of

the panel to 26-3/8" (669 mm).

2. To cover the face side of the ﬂoor board (a) add the thick-

ness of the ﬂoor board (usually 3/4" (19 mm)).

Thus, the minimum height of the freezer door panel is:

26-3/8" + 3/4" = 27-1/8"

(669 mm + 19 mm = 688 mm)

3. Without door panels on the unit, there is a gap of 2 5/8“

(67mm) between the freezer door and the refrigerator door.

After the installation of the cabinet doors, the gap between

the two doors will only be around 1/8” (3mm).

4. If there is other furniture standing close to the refrigerator

cabinet (See also previous page) this furniture typically has

a gap between two drawers or two doors. Depending on

your kitchen, these gaps are approximately 1/8" (3 mm)

wide.

5. In this case, the maximum height of the freezer door panel is:

26-3/8" + 3/4" + 2-5/8" - 1/8" = 29-5/8"

(669 mm + 19 mm + 67 mm - 3 mm = 752 mm)

Where as the minimum height of the freezer door panel is:

26-3/8" + 3/4" = 27-1/8"

(669 mm + 19 mm = 688 mm)

Of course, the ﬁnal door height depends on the gap position of

the cabinets that stand to the left and right of the refrigerator

cabinet.

6. The height of the refrigerator door panel is:

The total opening of the cabinet (i.e. 70-3/8" (1788 mm)) plus

the thickness of the top as well as the ﬂoor board (usually 3/4"

(19 mm)) minus the height of the freezer door panel (xxx" (xxx

mm)) and subtract the width of the gap (approximately 1/8" (3

mm)):

70-3/8" + 3/4" + 3/4" - xxx" - 1/8" = 71-3/4" - xxx"

(1788 mm + 19 mm + 19 mm - xxx mm - 3 mm = 1823mm –

xxx mm)

Deﬁnition of the Door Panel Heights

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

Pas de commentaire

Liebherr HC1050B Guide de l'utilisateur Page 28